Q: When plug the vag com 11.11 with your pc, it is not recognised and comes up as "FFFFFFFFFFFFF".Īny advise please?,It worked fine for the first 2-3 times.Ī: Reprogram it, you need Reflash the china vag com ![]() Step 6:- Copy loader to your VCDS directory. Step 5:- Solder 3 wires as shown on the pic with blue lines. Step 4:- Reflash GAL16V8 (ATF16V8) with dump. Firstly, supply 12V power to the Vag com VCDS interface, Connect ATMEGA 162 chip with port LPT of the pc to program it as shown on this picture: Step 2:- Remove components IC8, R50, R51, D7 as shown on the pic with red arrows. Here obd2tuning will sharing how to solve vag com vcds interface not find and can't recognise problem? vag com vcds error:ģ.) not plugged into car message / interface worxĤ.) can't update it to Vag com 12.10.3,and does not work, solution as below: and changed COM PORT in device manager on laptop to vcds.blue light flash on cable conector when connected to car! But message is the same- INTERFACE NOT FOUND! If you have the Vag group cars,when you need the diagnostic interface to diagnostic the vag cars,such as: audi,vw,seat and skoda.OBD2Tuning will recommend you choose the vag com vcds cable:īut Some customers feedback that: when they install vag vcds 11.11 or vagcom 11.11.3 on the laptop and connect to the car.but message was: interface not found.they also tried port 1,2,3,4 and usb. ![]() ![]() How to solve vag com vcds interface not find problem?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |